* FITS STANDARD 2″ DRAIN TWO PIECE TOILETS WITH 2″ TANK DRAIN AND 5/8″ TO 3/4″ SQUARE LEVER HANDLE HOLE * FlushSaver Reverse Lever Dual-Flush DIY Conversion Kit is EASY to operate for anyone because it looks and works much the same as a traditional flush handle toilet, but with one big difference . . . when the handle is toggled DOWNWARD as usual, it produces a water-saving “Number One” flush and then can be toggled UPWARD for a higher water-volume “Number Two” flush as required. The flush handle can also be positioned with the lever pointing downward for a LEFT-RIGHT flush orientation if preferred. Further, a pair of Die Cut Flush Indicator labels (one for Full Flush and one for Half Flush) are included for marking the flush direction so there is no confusion. Both the “regular flush” and “small flush” release enough water to fully cycle and empty the bowl, but the small flush is less aggressive and uses approximately 1/3 less water . . . adding up to over 10,000 gallons saved for an average family of four. Further, both cycles are adjustable to suit your particular tank size and water use preferences. This kit fits most common two-piece toilets with a separate tank and bowl configuration (held to together with long bolts). EVERYTHING is INCLUDED to fully replace ALL of the parts inside the tank as shown. The leaky and wasteful flapper mechanism is replaced with a MODERN adjustable, dual-action piston and seal evacuator column, while the old-style ballcock valve is replaced with a QUIET and SERVICABLE filler valve. The kit also includes a new tank gasket and non-corroding STAINLESS STEEL bolt set for a complete tank overhaul job. *ONE2FLUSH is a registered trademark of Being Water.