- Make sure this fits by entering your model number.
- 8 Foot self-adhering flexible sink form. Will conform to most undermount sinks.
- For double bowl sinks, the sink form can be notched with a utility knife to bridge the divider.
- Sink must have vertical walls!
- For tight radius corners, sink form can be heated with a blow dryer or heat gun to soften the plastic so it bends easier. If using a zero radius sink, sink form will have to be cut into 4 pieces (one for each isde of the sink).
- Read full instructions in product description below…
This fits your .
To use, adhere the sink form to the inside of an undercount sink (vertical walled sinks only). Keep the sink form at the proper elevation so that it is the same height as the rest of your countertop forms. A small smooth bead of silicone caulking should be used to seal the gap where the sink form meets the sink. This will also help give you a nice rounded reveal without any brittle edges. On sinks with tight radius corners, the sink form can be warmed with a heat gun in order to make the plastic more pliable. If the sink has square corners, the form may need to be cut into 4 separate pieces. For double bowl sinks, the sink form can be notched to span the divider.